308 shift shaft seal replacement

09-09-2003, 06:36 AM

Any tips on replacing the 308 shift shaft seal o-rings? The way I understand it is you remove dipstick tube then the sump and transmission cover. Undo the bolt in the fork holding the shaft to the shifter linkage in front. Undo the bolt holding the shaft to the selector inside the transmission. Jack up the rear of the transmision to allow the shaft to be withdrawn. Replace the o-rings and reassemble.

Close?

Thanks,
Stacy

09-09-2003, 06:57 AM

Welcome Stacy.

Looks like you've got it down very well.

Good luck and let us know how it turns out.

Regards, JRV

09-09-2003, 11:08 AM

Any idea what the dimensions for the o-rings are? I have ordered a couple from ferrari but I understand that 'Viton' o-rings are better and might try to source a couple if I knew what size.

Thanks

09-09-2003, 12:48 PM

Stacey,

I don't know the sizes, some of the other guys here might. I order most of my parts from the Factory unless I know for certian I can use an alternative that is without a doubt better than the original.

A lot of the time experimenting is not the best option unless the experiment can be reversed quickly and easily..

09-09-2003, 06:36 AM	#1 (permalink)
stacy o'blenes Posts: n/a	Any tips on replacing the 308 Any tips on replacing the 308 shift shaft seal o-rings? The way I understand it is you remove dipstick tube then the sump and transmission cover. Undo the bolt in the fork holding the shaft to the shifter linkage in front. Undo the bolt holding the shaft to the selector inside the transmission. Jack up the rear of the transmision to allow the shaft to be withdrawn. Replace the o-rings and reassemble. Close? Thanks, Stacy

09-09-2003, 06:57 AM	#2 (permalink)
JRV Posts: n/a	Welcome Stacy. Looks like y Welcome Stacy. Looks like you've got it down very well. Good luck and let us know how it turns out. Regards, JRV

09-09-2003, 11:08 AM	#3 (permalink)
stacy o'blenes Posts: n/a	Any idea what the dimensions f Any idea what the dimensions for the o-rings are? I have ordered a couple from ferrari but I understand that 'Viton' o-rings are better and might try to source a couple if I knew what size. Thanks

09-09-2003, 12:48 PM	#4 (permalink)
JRV Posts: n/a	Stacey, I don't know t Stacey, I don't know the sizes, some of the other guys here might. I order most of my parts from the Factory unless I know for certian I can use an alternative that is without a doubt better than the original. A lot of the time experimenting is not the best option unless the experiment can be reversed quickly and easily..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)