84 308QV EURO front cyl bank cuts out

[hlancer123]

84 308QV EURO front cyl bank cuts out after 10 minutes of running/hot after engine cools down no problem.
Have done following
1, swapped out from other side
1, magnetic electronic sensor
2. Digiplex
3. Coil
4. Dist, rotors note - no oil inside
Wires from sensor to Digiplex has continuity even when front bank is off
Gas dose not seem to be problem
All connections are seem to be clean.
What else should I be looking at

[Dinosar]

On my 308, the 11 pin connectors on the digiplex have fatigued and will give me the same kinds of issues. I'm tired of digging in the trunk area to wiggle the connectors. Time to permanently fix this. By the way - connectors seem impossible to find so may have to make my own.


Post script: It was the connector attachment to the digiplex PC board - not the connector itself (see my other post).

[jake213]

theres an article a couple posts up about the solder fix for this.