HELP !!!!
#1. I removed the front bearings to repack them and I forgot which way the bearing seal is installed- should the rubber lip on the seal point to the bearing or point toward the rear of the spindle ? see photo- the lip is pointing to the spindle in the photo, is this correct ?
#2. Does the spring steel ring fit between the bearing and the seal ? (or does it fit inside the seal ?)
#3. I can't get the rotor to turn when the caliper shims are installed, it acts like the hub isn't seated properly against the spindle , causing the rotor to stick out a little too far. Should the hub fit flush against the back of the spindle or should there be a gap
(I can't believe something so simple is driving me so crazy)
Steve
HELP !!!!
#1. I removed the
Linear Mode
