TR circuit board

Hello,
Need to cheak under the circuit board for a bad wire, I have removed the 16 screws, what is the best way to pop it off?? I don't want to hurt the board obviously!!
Thanks..Robert

".......removed the 16 screws....." WOW!

It has been a while since I replaced my mother board on the TR. After opening the "door", I recall only 4 bolts/screws that hold the circuit board on. After these are removed, the board comes out and down.......one can now look at the back side.

There is a row of relays above the board, that do not have to come out, if one just wants the board down.

Thanks,
I got it figured out!! I pulled out the board and found a burnt plug wire that goes to my L/H fan motor, I ran power thru it straight from the battery, and it works?? I thought the wire was short some where, but I guess not?? Just trying to figure out what made it cook?? I guess I will clean it up, and put back together and see if the fan will work thru the circuit board..still need to find out what happen!!
Robert

RBO,

the wires burn because of loose contacts creating high resistance = extreme heat across the connector/plug. Very common on Ferrari fan & fuel pump circuits. Insure the contacts are clean and tight.

Regards, JRV

Thanks JRV,
I will cheak all contacts and go from there!!
Robert