Ferrari Forums banner

1 - 3 of 3 Posts
G

·
Discussion Starter #1
I am helping with the replacem

I am helping with the replacement of the 4 Koni's on a 330GTC. Help is appreciated. There is insufficient clearance in the rear to remove the lower shock bolt without splitting the upper A-frame. Is this the correct procedure? Your experience is greatly appreciated.

Jim S.
 
G

·
Discussion Starter #2
Jim,

I did all 4 (sent


Jim,

I did all 4 (sent out for rebuild)about 3 yrs ago and can't remember the full procedure...mainly because I was replacing the a-arm bushings & pins at the same time. Might not be a bad idea to have a look at all the other associated suspension pieces while you're in there, as the bushes can get quite worn and sticky/bound, preventing free movement.

Regards, JRV
 
G

·
Discussion Starter #3
Bushing actually look pretty n

Bushing actually look pretty new. Must have been replaced in the not-so-distant past. If you get sudden insight into the procedure, let me know.

Thanks.

Jim S.
 
1 - 3 of 3 Posts
Top