Attaching TR block to trans case
G
I will be ready, this weekend,
I will be ready, this weekend, to secure the block to the trans case. I will plan on using "grey" sealant around the edges, with a new O-ring (and hylomar), for the oil tube going into the block, on the edge of the trans case. The o-rings beneath, under the block, for oil pick-up are good, so I will re-use them.
I plan on applying a small amount of hylomar sealant on these O-rings, to hold them in place while I place the block on the trans.
Have I missed anything? The sealant around the edges will be thin.
I will be ready, this weekend, to secure the block to the trans case. I will plan on using "grey" sealant around the edges, with a new O-ring (and hylomar), for the oil tube going into the block, on the edge of the trans case. The o-rings beneath, under the block, for oil pick-up are good, so I will re-use them.
I plan on applying a small amount of hylomar sealant on these O-rings, to hold them in place while I place the block on the trans.
Have I missed anything? The sealant around the edges will be thin.
1 - 1 of 1 Posts
1 - 1 of 1 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Ferrari Forums
A forum community dedicated to Ferrari owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
