[Guest]

Does anyone have a source for

Does anyone have a source for the small hard plastic lines for the injectors. Im told I can warm up the new plastic and slide in onto the existing steel line ends rather than replace the entire steel lines for the injectors.

 

[Guest]

The plastic line comes from Wi

The plastic line comes from Winzer, I think they are in Dallas. I took two peices of aluminum about 1"x2"x3/16" clamped them together and drilled a hole through the center. Now you can clamp these in a vice around the line without crushing it. Hold the line and fitting together and tap the fitting in with a hammer. If you need heat put it in boiling water. I like to do them cold.
Good Luck
Larry

 

[Guest]

Larry is spot on.

I use so

Larry is spot on.

I use soft jaws & a bic lighter.

 

[Guest]

Thanks Guys and Larry, Ill be

Thanks Guys and Larry, Ill be calling you soon again, been meaning to pick your brain.

Paul.