Ferrari Forums banner
1 - 1 of 1 Posts

Discussion Starter · #1 ·
clutch kit complete,release be

clutch kit complete,release bearing with seals,clutch sensor,sensor support,flywheel,end of stroke studs: all those items are replaced new.After doing a selflearn to the F1 gearbox ECU I have a clutch sensor error.Value too low.It is truely low since it is in closed clutch position at 13.35mm,I can solve this problem by adding shims under the sensor supprt base in order to increase the value,but why do I have to do this?since all parts are original and new?the old new clutch value was 18.25mm.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.