Ferrari Forums banner
1 - 1 of 1 Posts

Discussion Starter · #1 ·
JRV: Here are a couple of pic

JRV: Here are a couple of pics. The clutch aligns VERY snuggly with the flywheel bolts. Hence I had to tap the clutch every so often, because initial 11 ft-lbs of torque did not bring the clutch to the flywheel.

However, after tapping, the clutch went down, and the bolts where loose.....retorqued to 11 ft-lbs until completely flat with the flywheel. Then the final 11 ft-lb torque figure was correct.

Thought you may want to know.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.